Contax SW 2524 - REV A Przewodnik Instalacji Pobierz pdf (Strona 23)

Materials List

975-0637-01-01 Rev B 1–5

This guide for use by qualified personnel only

Conext SW AC/DC/Ports Side Panel

Figure 1-4 AC and DC Terminals, Network and Communication Ports Panel

Item Description

1 Battery Positive (+) DC terminal connects to the positive battery cable

(red). Install a DC terminal cover (supplied) over the terminal.

2 Battery Negative (–) DC terminal connects to the negative battery

cable (black). Install a DC terminal cover (supplied) over the terminal.

3XANBUS interface ports are used to connect Xanbus-enabled devices

including the optional SCP and AGS.

4STACKING port. Feature not available in these models.

5 Remote (REM) port provides connection for the on/off remote switch.

6 Battery temperature sensor (BTS) port provides connection for the

battery temperature sensor (supplied).

7 AC input/output lines wiring compartment access panel without the

compartment cover.

(a) AC Input terminal block is a screw-type terminal block for attaching

AC input wires. The terminals are labeled INPUT N for Neutral and

INPUT L for AC line respectively.

(b) AC Output terminal block is a screw-type terminal block for

attaching AC output wires. The terminals are labeled INPUT N for

Neutral and INPUT L for AC line respectively.

8 All earth

 (“ground”) terminals are along the tab (as shown) of the AC

wiring compartment access panel opening.

9 AC knockouts

" and

3/4

" provide access for AC cables (both input and

output wiring). Detach the knockout covers and install strain-relief

clamps available in hardware and electrical stores.

Not

shown

AC wiring compartment cover. Remove during wiring and replace

when wiring has been completed.

ConextSWEUROInstallationGuide.book Page 5 Wednesday, December 5, 2012 10:55 AM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 73 74

Brak uwag

Contax SW 2524 - REV A Przewodnik Instalacji Strona 23