Contax SW II - REV 4.01 Podręcznik Użytkownika Pobierz pdf (Strona 13)

AT-S73, AT-S99 and AT-S102 Version 4.0.1 Software Release Notes

PN 613-001136 Rev. B 13 Allied Telesis Inc.

AT-S73, AT-S99 and AT-S102 Version 4.0.1 Management Software

Known Issues

 DHCP client. The DHCP client on the AT-CV5M02 Management Card has the following known issues:

— There has to be a valid link on the 10/100Base-TX port on the management card before you can

enable the DHCP client.

— If the link on the 10/100Base-TX port is lost while the DHCP client is enabled, you aren’t allowed to

disable the client until the port’s link is reestablished.

— If, after the management card has received an IP address configuration from a DHCP server, the

server stops operating, the card retains its configuration. However, because the DHCP client

doesn’t periodically query the server for the status of its IP address configuration, it is unable to

determine whether or not its configuration is still valid when the DHCP server resumes operations.

 AT-CM70S Line Card. This line card has these known issues:

— The line card does not support the Line Card Configuration menu or tab, used to restore previous

configurations or the default configuration.

— The line card does not support packet rate limiting or flow control on the ports.

 Remote peer management. The remote management feature may not work during periods of heavy

traffic between local and remote line cards. If this problem occurs, the network operations of the cards

are not affected, but the Remote Configuration and Status menu will not display the remote card. Here

are possible workarounds:

— For the AT-CM2 Series Line Cards you can leave flow control activated on the ports on the local

and remote cards. These line cards are only likely to encounter the problem if you deactivate flow

control.

— For the AT-CM2K0S or AT-CM70S Line Card you can temporarily set the packet rate limit on the

twisted pair port on the local line card to 70 Kbps. You’ll then be able to manage the remote line

card. Afterwards, you can readjust the packet rate limit on the local twisted pair port back to no

limit or to whatever the previous setting happed to be.

 Web browser windows. The web browser windows have the following issues:

— You cannot configure the T1/E1 port settings on the AT-CM70S Line Card from the web browser

windows. To configure these ports you have to use the menus on the management card or the

card’s Console port. (6401)

— You can use the web browser windows to view but not change the IP address configuration of the

AT-CV5M02 Management Card.

 First RPS failure. The AT-CM3 Series Line Cards do not support the OAM first RPS failure signal if

the AT-CV1203 Chassis has one AT-CM3 Series Line Card and one AT-CM2 Series Line Card. The

line cards will work normally, but the AT-CM3 Series Line Card will not generate the signal.

 AT-CV1203 Chassis: The AT-CV5M02 Management Card in the AT-CV1203 Chassis may fail to

recognize the chassis model and may display “Unknown Chassis” above the Main Menu and in the

Chassis Diagnostics Menu. This issue does not affect the operations of the chassis, the management

card or the line cards. (6392)

Resolved Issues

No known issues were resolved in this release.

1 2 ... 8 9 10 11 12 13 14 15 16 17

Komentarze do niniejszej Instrukcji

Brak uwag

Contax SW II - REV 4.01 Podręcznik Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zasilacze i falowniki Contax SW II - REV 4.01